Jet JWS-34KX, Руководство по эксплуатации

Страница: 12 / 44

Router bits may only be operated in the highest spindle speed
(8000 rpm).
Disengage the spindle rotation lock.
Set the fence boards approx. 5mm close to the cutter rotation
(Fig 19.1).
Check if the spindle rotates freely and if all safety devices are
fitted and tightened.
Connect the machine to the power source.
Start the shaper cautiously.
7.4 Cutting tool installation
The cutting tool may only be changed when the spindle
rotation lock is engaged and the mains plug is pulled.
Risk of personal injury by cuts from the cutter knives. Wear
suitable gloves when changing cutters.
Clean all surfaces of cutters and spindle arbours with a
suitable solvent (do not use cleaning agents that could
corrode the light metal components).
To reduce the danger of kick-back and injury.
Only cutting tools marked “MAN” and conforming EN 847-1
respectively EN 847-2 may be used.
Unsuitable, incorrectly mounted, dull, cracked of bent cutter
knives can break or increase the risk of kickback considerably.
The installation of sanding or polishing tools is not
permissible.
The installation of saw blades is not permitted, high risk of
kickback and serious injury !
The cutter must be positioned on the arbour (F, Fig 18.1) as
low as possible (Fig 17).
Fig 17
Watch the sense of rotation (counter clockwise) when
mounting the cutter.
Fill the space between cutter (B, Fig 18.1) and clamping
washer (C) with spacing collars (E).
Fig 18.1
Tighten the tool with the socket hex screw (D, Fig 18.1)
securely. (Don’t use a wrench extension or a hammer to
tighten the screw)
Cover the clearance zone around the cutter with table insert
rings (A, Fig 18.2).
Fig 18.2
ATTENTION:
Adapt the spindle speed to the cutting tool diameter.
Never exceed the shown numbers of revolution (rpm, /min,
min
-1
) on the tool.
Disengage the spindle rotation lock.
Set the fence boards approx. 5mm close to the cutter rotation
(Fig 19.1).
Check if the spindle rotates freely and if all safety devices are
fitted and tightened.
Connect the machine to the power source.