Jet JWS-34KX, Руководство по эксплуатации

Страница: 8 / 44

Fig 3.2
5.3 Mains connection
Mains connection and any extension cords and plugs used
must comply with the information on the machine licence
plate.
The mains connection must have a 16A surge-proof fuse.
Only use extension cords marked H07RN-F, with wires
1,5mm
2
or more.
Power cords and plugs must be free from defects.
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
ATTENTION:
-Check first if the spindle rotates freely and if all safety devices
are fitted before starting the machine.
Make sure that the spindle is running the correct direction
(counter-clockwise).
- If the direction of rotation is not correct, the phase converter
inside the CCE Euro plug must be pushed in and turned 180°.
(See rotation arrow on machine for correct rotation, Fig 3.3)
Fig 3.3
5.4 Dust connection
Before initial operation, the machine must be connected to a
dust extractor. The suction should switch on automatically
when the shaper is switched on.
The flow rate on the suction port must be 20m/sec.
Flexible hoses must be of “non-flammable” quality, and must
be connected to the machine ground system.
Reduction of dust exposure:
Exposure to high levels of airborne dust can damage your
health.
Use a suitable dust extraction system (see chapter 4.4 for
minimum volume flow and vacuum pressure).
Avoid long / angled suction lines as these reduce the volume
flow considerably.
Make sure the room is well ventilated.
Use respiratory protection.
5.5 Starting operation
You can start the machine with the green on button. The red
button on the main switch stops the machine.
In case of overload the motor overload cut-off will react. After
approximately 10 minutes of cooling the machine can be
started again.
6. Machine operation
Correct operating position:
Position yourselves offset to the machine front (Fig 4).
Fig 4
Workpiece handling:
Feed the workpiece straight across the machine table, holding
your fingers close together, guiding the workpiece with the
palm of your hands.
Never put your hands under or behind the shaper guard.
Always keep your hands well clear of the rotating cutter.
Always feed the workpiece against the cutter rotation (Fig 4).
Use a push block when working the ends of narrow stock.
Use a feeding aid if you are going to work a workpiece shorter
than 300mm.
Always machine the workpiece over its entire length.
Recess machining may only be carried out with the aid of
suitable longitudinal workpiece stops (Fig 5) ….high danger of
kickback!!!