28
CAUTION
For balancing programmes 5 and 6, the correction weight for outer correction place should be
attached in the plane of the faceplate (at the inner side of the rim).
The stick-on weights cannot be removed and stuck again. Therefore, upon displaying the
values of imbalance, a weight smaller by 5
–10 g than the one indicated by the balancer
should be stuck. In the subsequent measurement it is possible to correct the residual
imbalance by sticking another, smaller weight (e.g. 5 g) in a new position of imbalance
indicated by the wheel balancer. In this manner it is plausible to avoid possible correction of
the position by moving the weight, what is undoable for stick-on weights.
5.2.1 Calculation of imbalances
This function enables to quickly obtain the correct values of imbalance in the event when the
measurement was performed upon entry of incorrect parameters of a wheel.
Example:
Incorrect data regarding the wheel to be balanced are entered to the machine’s memory. The
measurement is performed, but the results are not true. If one wants to know the real values
of imbalances for this wheel without the necessity to perform another measurement, it suffices
to enter correct data
to the machine’s memory and press the button
The wheel balancer will display correct values of imbalances.
5.2.2
“Hidden weight” programme
The “hidden weight” programme is used when the user wants the correction weight for the
outer side of the wheel not to be visible in ALU subprogrammes (variant 5 and 6). The
programme enables to split the imbalance displayed in the indicator screen between two
correction weights which should be stuck behind two arms of the rim (spokes) located in the
nearest distance to the left and right from the imbalance position.
Procedure
of the “hidden weight” programme
1.
Select variant “6” or “7” of the balancing programme.
2. Initiate measuring cycle.
3. After the wheel stops, correct the imbalance for the inner correction plane.
4. Imbalances shown for the outer correction plane should be corrected with the use of two
weights according to the following procedure:
4.1. Position the wheel so that the correction position is in the topmost point of the rim
(sound signal and arrows directed towards each other).
4.2. Press the button 3P. The indicator screen shall display 3P and Pt-1.
