23
5.1.5 Entry of the cut-off threshold value
Press the button
on the keyboard.
In the indicator screen the pictogram
will be set at the height of pictogram
. The wheel
balancer has three values of the cut-off threshold: 2 grams, 5 grams and 40 grams. By pressing
button
or
it is possible to increase or decrease the cut-off threshold.
CAUTION
The cut-off threshold [value Q=0] shall be deactivated by pressing button
STOP
, holding and
then pressing button
Q
.
5.1.6
Wheel balancer’s memory / User’s memory
The wheel balancer has two memories: M1, M2, which enable to save parameters for two
different wheels. In order to enter data to the memory, e.g. M1, appropriate parameters should be
displayed by pressing buttons
and . Then values of the parameters must
be set by means of buttons
or
. Press button STOP and while holding it press button
. Press button
in order to read out the data previously saved in the memory. For
other memories, the respective buttons
should be used.
5.1.7 Wheel balancer drive
The wheel balancer has a manual shaft drive. In order to bring up the wheel to proper speed
level, hold the ball of the adapter nut and spin the shaft in the direction of the arrow on the wheel
balancer casing. The wheel should reach the rotational speed higher than 95 rpm. Value of the
rotational speed is displayed in the indicator screen. If the rotational speed does not exceed 95
rpm, the indicator screen shall not display any values and the measuring cycle shall not be
initiated.
If after spinning the shaft the obtained speed is higher than 130 rpm, this value shall be displayed
in the indicator screen, the measuring cycle shall be initiated when the shaft revolutions slow
down to 130 rpm. Completion of the measuring cycle is signalled by displaying the value of
imbalance in the indicator screen.
Example:
Obtained rotational speed 125 rpm
