22
Bed Setup (Front and Rear) (For Kiwi Models Only)
IMPORTANT:
We recommend that well in advance of any trip, you set up your Kiwi travel trailer
and using a garden hose, thoroughly soak the tent with a light spray of water. After
the tent dries, repeat the soaking process three additional times. This process seasons
the canvas and seams. DO NOT spray directly on the canvas with a high pressure
hose. If you do not follow this procedure, you may experience some water seepage
during the first few exposures to rain. Let the tent dry thoroughly before storing to
prevent mildew and odors. If you note any water seepage or leaks after seasoning
your tent, let the tent dry, then spray water repellant on the INSIDE of the seams
where seepage occurs. One or two applications of water repellant may be necessary
to stop all water seepage in seams where thread enters the fabric. NOTE: Touching
the tent canvas when it is wet can cause leakage. If leakage persists, please contact
your dealer for assistance.
NOTE:
For storing purposes, the Kiwi travel trailer is equipped with canvas straps to
hold the bed tent. Prior to setting up the Kiwi beds, the canvas straps should
be unhooked by using the clips at the top edge. (The JA model also has one
strap on the rear bed.)
1. Locate the bed brace supports found in the roadside front compartment and insert
one end into the brace receptacle located on the tongue in front and on the bumper
in rear.
2. Unscrew the latches or knobs that hold the bed board in place to release the bed
board. This process can be performed by one person, but works better with two.
3. Slowly lower the bed board into position and insert the other end of the bed brace
into the receptacles located on the bed board.
CAUTION: The bed board must be supported at all times. If the bed board should
fall, damage will occur to the unit.
4. Place the bed bow on top of bed cushion and pull bed cushion to the outer edge of
the bed board.
5. Place the bed tent over the edge of the bed board and snap it into place. Make sure
when the tent is set up that it is tucked into the “J” rail molding.
6. When tent is snapped into place, pull the edge of bed tent in an upward direction to
remove tent slack from under bed board.
7. Enter the unit and place the straight end of bed bow support pole onto the bow peg.
Push the bow outward and upward while pressing the second button from the curved
end of the bed bow support pole. Slip it onto the bracket mounted on the roof just
past the first button. Release button.
8. Unfold the bed cushion and place the separate thin cushion under the extension to
level the cushion.
Содержание Kiwi
