13
Hookup
Hooking up a travel trailer is not difficult and will become easier with practice. The
following procedure will help you until you become more experienced.
1. Block Wheels.
2. Turn crank on jack to raise tongue of trailer above hitch ball on hitch.
3. Open coupler latch.
4. Back tow vehicle into proper position.
5. Turn crank on jack to lower coupler onto ball hitch.
6. Close coupler latch after completely seated.
7. Install weight distributing bars (equalizers) as per recommendations from hitch
supplier, when required.
8. Remove dolly wheel and retract tongue jack to its maximum height.
9. Attach cable for break-away to tow vehicle.
10. Attach safety chains as shown in Figure 3-1.
11. Plug in your 12-volt electrical connector from tow-vehicle to trailer.
12. The following items should be inspected prior to your journey:
• All lights should be in working order.
• Stabilizer jacks should be in the retracted position.
• Entrance steps should be in the retracted position.
• Refrigerator door should be closed and locked.
• All loose items should be secured.
• Brakes should be tested for operation prior to entering roadway.
• Tire pressure should be checked and maintained per the tire pressure stamped on
the tire sidewall.
The Safety Chain
There are different safety chain requirements determined by the various state laws. Your
vehicle is equipped with chains to meet SAE standard requirements for maximum gross
trailer weight. Always have the safety chains attached when towing. Install them as
shown below so they do not restrict sharp turns, but tight enough so they do not drag on
the ground. (Fig. 3-1)
Содержание Kiwi
