Japan Radio Co. JSS-2150, Руководство по обслуживанию

Страница: 74 / 160

SETUP AND ADJUSTMENT
2-14
2.2.5.2 Checking the I/O ports
Check the connection status by monitoring input signals or outputting simple data.
z
Port selection
RS-485 monitor: Connected controller
AME monitor/output: AME
DMC output: DMC
GPS monitor: GPS
RMS monitor/output: Remote maintenance
z
Data output
When AME, DMC or Remote maintenance is
selected at Port selection, pressing ENT on
Execute outputs the data from that port.
z
Port monitor
When other than DMC is selected at Port
selection, the monitor screen appears and
the monitoring begins.
z
Port monitor log
After obtained logs at Port monitor, displays
the log screen and that information.
Note:
¾
The signal output at Data output is as follows.
- For AME, [$CTALR,,999,,,*hh <CR><LF>] is output.
- For DMC, after RDY and DRA are turned on for 3 seconds, DAL is turned on for 3 seconds. At
that time, [MF/HF], [DISTRESS], and [MF/HF DSC] lamps and buzzers operate respectively.
* During this testing, no transmission is occurred.
- For Remote maintenance, [$PJRCM,CT,4,cxxx,cxxx,cxxx,cxxx,cxxx,cxxx,cxxx,cxxx,cxxx, *hh
<CR><LF>] is output (Note: cxxx is the version of each unit).
¾ On the Port monitor, a screen like that to the lower left appears. Also, pressing ENT on this
screen displays a popup screen like that on the lower right, and a log for a set period of time can
be obtained.
¾ On the Port monitor log screen, after pressing ENT on this
screen to display the popup screen to the right, select OK
and press ENT to output data from the maintenance port of
the controller.
D a t a l o g g i n g . . .
[ S t a r t ] [ C a n c e l ] [ S t a r t ]
D a t a l o g g i n g . . .
[ S t o p ] [ C a n c e l ] [ S t o p ]