Japan Radio Co. JSS-2150, Руководство по обслуживанию

Страница: 69 / 160

SETUP AND ADJUSTMENT
2-9
2.2.4 How to configure settings
The details for the field maintenance menu (F1. Initial setting) are as follows (in order of menu
numbers).
2.2.4.1 MMSI registration
To use DSC, register the ship's MMSI assigned by the supervising authority.
z Operate the ENT key to move the cursor to
the right of Self-ID(MMSI). Use either the
numeric keypad or the jog dial to enter the
9-digit MMSI and press ENT.
z
Entering all 0s (000000000) erases the
registration and the ID number displayed in
the upper-left changes to “MMSI
：
invalid”.
2.2.4.2 Serial number registration
Register the serial number (manufacture's number) written on the plate of each unit.
* Scrolling with the jog dial on the screen above displays the screen below.
z
Move the cursor to the right of the items
under 2. Serial number on the screen above
and then enter the serial number.
z
After displaying the letters, such as BS,
using the jog dial press ENT.
2.2.4.3 DMC/AME settings
Configure the connectivity settings if NCH-321A DMC or AME are connected.
Caution: Setting 2. GPS to off on this menu does not sound an alarm when GPS information has not
yet been entered. Because this means non-compliance with international standards (ITU-R
recommendation), always leave it on, except for special ships.
z
DMC
To use DMC: ON
To use simple AME: Exp*
To not use DMC: OFF
z
GPS
To use GPS: ON
To not use GPS: OFF
z
AME
To use AME: ON
To not use AME: OFF
* When installing a simple AME device for DSC receiving alarms and the alarms cancel, connect it to DMC_DAL,
DMC_DAS, DMC_OAL, and DMC_OAS terminals on the CQD-2416 and set “DMC : Exp” here.