JANDS 4Pak-D
- 6 -
User Guide
To record and playback a User Chase sequence:
User chase sequences are fully programmable up to 32 steps long.
1.
Press the Display Mode button if necessary to put the Display into Prog (Chase)
mode.
2.
Ensure the Chase is not active ie the Go/Load LED is not illuminated.
3.
Using the [+] or [-] buttons choose a chase sequence from U 1 to U 9.
4.
Press the Enter button to start recording the selected chase.
5.
Adjust the channel levels as necessary for the step.
6.
Press the Enter button to record the levels.
7.
Repeat steps 5 and 6 until all steps have been recorded.
Note that any step may be re-recorded if necessary by using the + and - buttons to select the
step, adjusting the levels as required, and pressing Enter to record. To view the step levels,
press and hold the Chase button while the step number is displayed. Release the Chase button
to continue.
Press the Exit button to get out of chase record mode.
To activate the chase, press the Go/Load button.
It is possible to delete all steps from a point onward for example, steps 5 and 6 of a 6 step
chase. To delete all steps from step 5 onward Enter Chase record mode, select the first setp to
be cut, then press and hold store for 3 seconds. The 4Pak-D flashes CUT and pressing Enter
again confirms the deletion.
To delete the entire chase, press Cancel and Enter together while the chase number is
displayed. The 4Pak-D flashes CFR and pressing Enter again confirms the deletion.
Scene Operation
A Scene allows the operator to assign pre-recorded dimmer levels for all channels to a single
channel fader. There are a total of four pages each containing 5 scenes.
To record and playback a Scene:
1.
Press the Display Mode button if necessary to put the Display into Prog (Chase)
mode.
2.
Ensure the Chase is not active ie the Go/Load LED is not illuminated.
3.
Using the [+] or [-] buttons choose a Scene page from S 1 to S 4.
4.
Press the Enter button to start editing the selected scene page.
5.
Adjust the channel levels as necessary for the scene.
6.
Press the Enter button to record the levels.
7.
Repeat steps 5 and 6 until all 5 scenes have been recorded. The display will
show FUL when all 5 scenes on the page have been programmed.
Note that any scene may be re-recorded if necessary by using the [+] and [-] buttons to select
the scene, adjusting the levels as required, and pressing Enter to record them.
Press the Exit button to leave scene record mode.
To activate the scenes, press the Go/Load button. The channel faders and flash buttons are
now used to control scenes 1 through 4, while the rate fader is used to control scene 5.
To delete the Scene page, press Cancel and Enter together while the Scene page number is
displayed. The 4Pak-D flashes CFR and pressing Enter again confirms the deletion.
Содержание 4Pak-D
Страница 1: ...Supplied by...
