JANDS 4Pak-D
- 3 -
User Guide
Introduction
The 4Pak-D is a four channel integrated desk/dimmer unit with extensive chase and scene
facilities plus the ability to be driven from an external DMX-512 source. It has been designed
for applications where portability and ease of operation are prime considerations.
The 4Pak-Ds enhanced chase facilities include nine factory-programmed chases, the ability to
store nine user chases each up to 32-steps, forward, reverse, and bounce modes, crossfade
mode, and the ability to trigger on the room sound via the inbuilt microphone.
The 4Pak-D includes the ability to replay 5 scenes at once under the control of the 4 channel
faders and the chase level fader.
A DMX input is provided to allow remote control of the dimmer channels from a standard
external control console. The DMX connections also enable up to four 4Pak-Ds to be linked
and used/controlled as one unit. This DMX link functionality uses DMX-RDM data packets
and if desired the 4Pak-D may be used with other RDM equipment.
Before Use
1.
Place the 4Pak-D on a flat stable surface. Ensure the area around all chassis vents is
clear with no obstructions.
2.
Set all fader levels to zero.
3.
Plug lights into the four output sockets. The total and individual channel loadings
should not exceed the specified maximums.
4.
Fully uncoil the power cord and plug into an earthed power outlet. Note that the
power inlet connection must remain accessible at all times during use.
5.
Switch on the front panel circuit breaker/s.
6.
Switch on the power at the wall. When the 4Pak-D has completed scrolling the startup
message the unit is ready for use.
It is recommended that the unit be deep cleared before the start of each different show so that
the operator has a clean slate. Refer to page 5.
During Use
The 4Pak-D may get hot during use, especially at the rear near the vent holes. This is normal
and the vent holes must remain unobstructed for the 4Pak-D to operate correctly. Inadequate
ventilation may result in product shutdown.
Note also that the circuit breaker/s are not a main switch and must not be used to turn the
product on or off. However this breaker may trip during use if the output loading is too high,
if a lamp filament blows, or if there is a faulty output cable. If this occurs, rectify the fault and
return the Master
fader
to zero before resetting the circuit breaker.
Do not expose this product to dripping or splashing liquids. Do not place objects filled with
liquid anywhere on or near the 4Pak-D chassis.
After Use
Switch off the mains supply at the wall when not in use.
Содержание 4Pak-D
Страница 1: ...Supplied by...
