JANDS 4Pak-D
- 2 -
User Guide
Copyright & disclaimer
This product is approved for use in Europe and Australia/New Zealand and conforms to the following standards:
EN61000-6-1
EN55015:2000
EN60065
Conformance has been achieved for intended usage in environment E1: Residential.
To ensure continued compliance with EMC Directive 89/336 and the Australian Radio communications Act 1992,
use only high quality data cables with continuous shield, and connectors with conductive back shells. Examples of
such cables are: DMX: Belden 8102 (100% Aluminium foil screen, 65% Copper braid)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not properly
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
reorient or relocate the receiving antenna;
increase the separation between the equipment and receiver;
connect the equipment into an outlet on a different circuit from that to which the receiver is connected;
consult the dealer or an experienced radio/television technician for help.
Disclaimer
Information contained in this manual is subject to change without notice and does not represent a commitment on
the part of the vendor. Jands Pty Limited shall not be liable for any loss or damage whatsoever arising from the use
of information or any error contained in this manual. It is recommended that all service and repairs on this product
be carried out by Jands Pty Limited or its authorised service agents. Jands Pty Limited cannot accept any liability
whatsoever for any loss or damage caused by service, maintenance or repair by unauthorised personnel, or by use
other than that intended by the manufacturer. Jands lighting products must only be used for the purpose they were
intended by the manufacturer and in conjunction with the user manual.
Disconnect mains power when not in use.
Designed in Australia by:
JANDS Pty Ltd
ACN 001 187 837
Locked Bag 15
40 Kent Rd
MASCOT NSW 1460
MASCOT NSW 2020
Sydney Australia
Sydney Australia
Phone: +61-2-9582-0909
www.jands.com.au
Fax:
+61-2-9582-0999
Manufactured in China.
Copyright JANDS PTY LIMITED 2008
Revision 1.0
All rights reserved
29 November 2008
Содержание 4Pak-D
Страница 1: ...Supplied by...
