JANDS 4Pak-D
- 5 -
User Guide
Operation
General Rules
The operation of the 4Pak-D is defined by a few simple rules:
The mimic LED in the channel flash button always shows the channel level.
The Master fader always scales the level of the faders and the chaser output.
The channel flash buttons always flash the contents (either channel or scene) to full.
The DMX signal is always mixed with the channel faders, flash buttons, and
chaser/scene output on a highest takes precedence basis.
Deep Clear
It is occasionally useful to clear out all user recorded scenes and chases and reset the unit to
its defaults - this is achieved using the “Deep Clear” function. To Deep Clear a 4Pak-D:
1.
Turn the power off.
2.
Press and hold the Enter and Exit buttons.
3.
Turn the power on. 4Pak-D will display CFR, looking for confirmation.
4.
Release the buttons from step 2.
5.
Press the Enter button.
The 4Pak-D will take about 30 seconds to completely Deep Clear its memory.
Chaser Operation
The Chaser has 9 pre-programmed chase sequences (C 1 through C 9), each is either 3 or 4
steps long, plus a further 9 user programmable chases sequences (U 1 through U 9) each up to
32 steps long. Chases are activated by selecting the required chase and pressing the Go/Load
button.
At any time the Direction button, Crossfade button, Audio button, and Rate fader may be used
to control the chase playback as required. When the Rate fader is at 0, the chase may be single
stepped using the [+] and [–] buttons.
The active chase can only be changed when the chase is
not
running.
To select and run a Factory Programmed Chase sequence:
Factory programmed chases can be used to quickly get a show going.
1.
Press the Display Mode button if necessary to put the Display into Prog (Chase)
mode.
2.
Ensure the Chase is not active ie the Go/Load LED is not illuminated.
3.
Using the [+] or [-] buttons choose a chase sequence from C 1 to C 9.
4.
Press the Go/Load button to activate the selected chase.
Use the Direction, Crossfade, and Audio button and the Rate fader while the chase is running
to control the chase playback. Note Chase C 9 runs chases C 1 through C 8 sequentially and is
ideal for unattended use.
Содержание 4Pak-D
Страница 1: ...Supplied by...
