background image

7

GB - Instructions for the use of LiPo Batteries

Important Notice

Read the manual and the safety precautions for the
Lithium-Polymer-Cells properly.

-  Litium-Polymer-Cells have no memory-effect
-  Lithium-Polymer-Cells are recharged with a constant voltage    
  and a constant power
-  Lithium-Polymer-Cells have a small self-discharging Voltage

Liability exclusion
Jamara e.K. assumes no liability in case of wrong usage or 
operation of the product, respectively of all injuries.
The customer alone is in charge of the cell, this includes 
from the recharging process up to the choice of place of 
use.
If the customer is not satisfied with the terms of usage, 
he may use his right to return the unused product to the 
dealer.

Lithium-Polymer-Cells may only be stored and recharged, on fire-

proof non-flamable grounds. Jamara e.K. recommends to recharge 

the cells only with the transmitter. When using an other charger or 
when using the permitted charger incorrect, no liability can be ta-
ken. Because of their enormous power-compactivity Lithium-Poly-
mer-Cells are flameable when damaged. This can happen through 
extrem overcharging, a crash or a mechanical damage etc. There-
fore, it is extremly important to supervise the recharging process. 
After a crash the cell/pack should be checked carefully. For examp-
le the cell/pack could have been damaged, but does not heat up 
before 30 minutes. So, in case of a damage at one pack or a cell 
always strictly supervise.

If the cell overheats, swells, burns or smoke is coming from 
it, do not touch it under any circumstances. Keep away in 
a safe distance and prepare adequate extinguishing agents 
such (No water explosion, well dry sand, fire extinguishers, 
fire blanket, salt water).

Safety precausions

Because of the high power  compactivity (up to 150 Wh/kg) the 
cells are quite dangerous and need  special care!  The company 

Jamara excludes explicitly, all types of liability for damages, that can 

occure when using the Lithium-Polymer-Cells indequate.

-  When using the battery incorrect there is a risk of getting 

  fire- or acid-injuries.
-  Overcharging, too high power, or discharging at low level

    destroys the cell.
-  Protect from mechanical stress (squeezing, pushing, bending, 
    drilling).
-  Never open or cut open, do not throw into fire, keep away  

 

  from children.

-  Handle damaged or leaking battery with care. Injuries or

  damages to the product can occure.

-  Under no circumstance short-circuit the device and always  

 

  watch out for correct polarity.
-  Protect batteries from heat above 65 °C , mount away from 

  hot objects (for example exhaust pipe).

-  Before storing batteries (for example in the winter) charge 
  the battery. Do not store in fully charged or in non charged 
 state!

-  If stored over a longer period of time, observe the power l 

 

  evel occasionally.
-  The contents of the cell is harmfull for skin and eye.
-  If the content comes into contact with skin, clean with plenty    
  of water and take off moisted clothes.
-  If the content comes into contact with the eyes, clean with
    plenty of water and consult a doctor.

Technical data

Case:

 

The case of the cells consists of an aluminium-plasticfoil. This foil 
should not be damaged under any circumstance, because this will 
lead to a damaged cell. Take care of sufficient protection (i.e. vib-
rations) in the model. If damaged, they might leak, avoid contact 
under all circumstances.

Overcharging:

If charging does not stop because of any damage to the char-
ger the battery may catch fire. Therefore supervise the charging 
process frequently. 

Speed charging:

Speed charging is not possible. The charging voltage for these 
cells must be followed.

Charging temperature:

 

0 to +45 degrees outside temperature. During charge, the bat-
tery should not get warmer than 70 °C. Supervise the charging 

process with help of the JAMARA Thermo Scan 300 ( Non-touch 
infrared thermometer)  Order No. 17 0133.

Discharging temperature:

-20 to +60 degrees: Flying in winter is therefore possible. At tem

-

peratures beneath 0 degrees, it is likely that the capacity may be 
reduced by approx. 20% and the discharge level may be smaller 
as well.

Lifetime: 

Very user-dependent.

Storage:

The cells need to be between half full and full charged. The 
storing empty cells will lead to their destruction. New cells are 
therefore half full.

Содержание 00 7280 PNP





















Отзывы: