Manual
EVO controller
11
www.jakkagroup.com
In order to change the settings of each day, just select the day in the summary display window and press OK; now, the detail screen
of the selected day is displayed with the list of the eight possible time periods (C1
C8), while the selected day of the week is displayed
in the top left corner of the screen.
After customizing one day of the week according to your need (for instance, Monday), you can copy your program to another day
without repeating the procedure described above. In the time period summary window, select the day you want to copy the previous
program to (for instance, Tuesday), and press OK. Now, the detail window of the time periods of the selected day is displayed. Scroll
all of the time periods using the down arrow key and reach the Copy day line (it will be after the C8 time period): highlight this line and
press OK.
Post-heating disable
Post-heating enable
Selecting the time period to be changed
Changeable parameters in the selected time period
You can change the content of a time period by selecting the period and pressing OK in the time period change screen; the graphic
summary of the program for the entire day is displayed in addition to the selected day (top left corner).
The parameters that can be changed are as follows:
- Change: change the time period you are working on without returning to the previous page by selecting this line and pressing OK:
scroll the several time periods (1
->
8) using the arrow keys and just press OK when you reach the desired period.
- Time hh.mm: set the starting time of the current time period by selecting this line and pressing OK: the arrows keys increase (up arrow)
or decrease (down arrow) the time by 30-minute steps; press OK when you find the desired value; the value of this parameter can be
comprised between the beginning of the previous time period and the beginning of the next time period.
- Fan speed xxx: set the fan speed (or the full-scale pressure/flow for machines without cop/cav kit), the flow per unit at constant pressu-
re or the pressure for units at constant pressure with cop/cav kit required for the current time period by selecting this line and pressing
OK: scroll the three possible values (low, medium and high) using the arrows keys; press OK when you find the desired value. These
values match the settings according to next paragraph (Speed level setting).
- Heat/Cool on/off: this parameter is only visible if the control is configured to run an air post-treatment device; enable (on) or disable
(off) the air post-treatment device by selecting this line and pressing OK. Scroll the two possible values (on and off) using the arrow keys:
press OK when you find the desired value. When the timer modality is selected is visible on the screen if the post-heating hourly is enable
(Ton) or disable (Toff).
