Jacobsen HR-9016 Turbo, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 83 / 92

QUALITY OF CUT 12
en-82
12Quality of Cut
12.1 QUALITY OF CUT PROBLEM SOLVING________________________________________
Make a “test cut” to check the performance of the mower before you start the repairs.
This area must have turf conditions that are known and do not change across the area. This type of area allows an
accurate inspection of the performance of the mower to be made.
Another “test cut” must be done after the repairs or adjustments to confirm the mower’s performance.
Before you do a “test cut” to show the appearance and performance of the mower, the following items must be
confirmed. These items make sure that the “test cut” is accurate.
1. Cut (Ground) Speed
2. Blade Sharpness
3. Height-of-Cut (HOC)
4. Caster Wheel Bearing Condition
5. Blade Speed
12.2 WASHBOARDING__________________________________________________________
NOTE: Arrow indicates direction of travel.
Washboarding is a repeated pattern of different cutting
heights, that causes an appearance that is like a wave. In
most cases, the wave tip-to-tip distance is approximately
6—8 in. (15—20 cm). A change in the color (from light-to-
dark) is also seen.
This cause of this condition can be a movement from side
-to-side in the cutting units (s). This condition is found on
mowers with cutting units held under the mower, but other
cause can give the same result.
Another cause of Washboarding is differences in the type
of turf.
Probable Cause Remedy
The cut (ground) speed is higher than normal. Reduce the cut (ground) speed.
Cut in the same direction. Change the direction of cut more frequently.
Cutting units have too much or too little weight on
them. Adjust the weight transfer valve to increase weight on the
cutting units.
Not enough engine speed, engine speed is not set to
specification. Check/adjust the engine speed.
Hydraulic system and deck drive motor performance is
decreased. Check the hydraulic system performance (pump output,
motor operation, valve operation and relief valve
settings).
TN0159