Jacobsen HR-9016 Turbo, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 45 / 92

OPERATION 7
en-44
7.8 MOWING SPEED __________________________________________________________
The cutting quality is improved at speeds lower than the transport speed of the mower. A mow speed of 6 to 7 mph (10
to 11 km/hr) is set at the factory and is correct for most conditions. The local turf conditions can need a different speed.
If the adjustment is needed, see
Section 10.2 .
7.9 MOWING
_________________________________________________________________________
To mow:
1. Set the 4WD switch to the 4WD position and the PTO switch to the ON position.
2. Lower the cutting units to the ground. When the cutting units are lowered, the blades will start turning.
3. To lift the front and rear cutting units, pull and hold the lift levers until the cutting units are fully lifted. The blades
will stop turning when the cutting units are lifted.
WARNING
To prevent injuries, when the blades rotate, keep your hands, feet and clothing away from the cutting unit.
NEVER use your hands to clean the cutting units. Use a brush to remove grass from the blades. The blades can be
sharp and can cause injury.
DO NOT operate the cutting units without the rear deflector chute or the mulching plate installed.
NOTICE
The 4WD switch must be in the ON position for the PTO switch to engage the mowers.
NOTICE
To prevent damage to the mower, make sure that the transport latch is disengaged before you lower the wing decks.
!