![background image](http://html.mh-extra.com/html/izzy/apollon-8030/apollon-8030_instruction-manual_2099115027.webp)
26
Faults: Reasons and Solutions
Problem
Possible cause
Solution
Not enough heat or too
much heat on the
soleplate
- The temperature dial is not set
to the correct temperature.
- The iron is unplugged.
- Set the temperature dial to
the appropriate temperature
according to the fabric to be
ironed.
- Plug in the appliance.
No steam or leakage
The temperature dial has been
set to
“
MIN”.
Set the temperature dial to
higher temperature.
No surge of steam or no
vertical steam
- There is not enough water in the
tank.
- The temperature dial has been
set to “MIN”.
- The shot of steam button has
been used too often between
each press within a very short
period.
- The water tank must be at
least 1/4 full of water.
- Set the thermostat to high
temperature.
- The iron should be in the
horizontal position. Press the
Burst of Steam button briefly.
Allow short time intervals
between shots.
Make sure to press the burst of
steam button fully.
Leaking water from the
soleplate
The tank is filled with water more
than the maximum indication.
Pour out the extra water from
the tank.
Little steam output
- The steam knob may be in “0”
position.
- The steam holes are blocked.
- There is not enough water in the
tank.
- Set the steam knob to the
desired steam level.
- Perform the self-clean
procedure.
- Fill the tank with water as
described in the section “Filling
the Water Tank”.
No spraying
- There is not enough pressure or
there is air inside.
- There is not enough water in the
tank.
- Press the spray button
several times continuously.
- Fill the tank with water as
described in the section “Filling
the Water Tank”.