Submersible Cable Interior Assembly
TOOLS REQUIRED:
5/16” Hand Drive Socket
or
Flat Head Screwdriver
Pliers
STEP 1:
Locate the submersible electric cable
assembly and notice the 4-pin male cordset spliced
onto one end. Next locate the Motor Control Cord
mounted on the Tri-Frame of the machine with a
4-pin female cordset.
STEP 2:
Connect the 4-pin male cordset to the
4-pin female cordset by pushing the two ends
together.
STEP 3:
Locate the white cord coupling halves and
screw clamp. Place the two cord coupling halves
around the black shrouds of both 4-pin cordsets as
shown. Firmly press the two halves together.
STEP 4:
Install the screw clamp around the two
coupling halves. Tighten the screw clamp while
making sure it is seated in the recessed groove
which is centered on both coupling havles
STEP 5:
Once the connection is made, neatly route
the submersible cable along the machine frame,
float arm, and float where it will not be in contact
with sharp edges or moving components.
STEP 6:
Using a quick link, connect the kellem grip
to the float plate to provide additional cable strain
relief in the event that the cord becomes taught.
This will avoid damage to the motor controller and
motor.
Kellem Grip
Connection Point
©2022 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | [email protected]
Equipment Assembly
458_10264_20220110
O&M_SB5000PW_10272_20220119 - 26
