Float Assembly
NO TOOLS REQUIRED
STEP 1:
Locate one float, one float arm, one float
bracket, and 2 float pin sets. Observe that there are
two slots on the top of the float which fit around the float
arm. One slot runs left and right, the other runs front to
back. If float pins are in the slots, remove them.
STEP 2:
Orientate the float so that it will fit around the
float arm when the float is raised into place.
STEP 3:
Place the float plate into float slot 1 furthest
from the core unit assembly aligning the holes of the
float slot with the small holes on the float plate (see
photo).
STEP 4:
Once the float plate is in place on the float,
raise the float up fitting it into the float arm. Use the
float pins to secure the float to the float arm.
STEP 5:
Place hairpins in each float pin to secure it
and prevent the pin from coming out.
STEP 6:
Repeat Steps 1 through 5 for the other two
floats.
NOTE:
The float plate may not be used on one of the
three floats.
After familiarizing yourself with all the components and
gathering the necessary tools, you are ready for setting
up the machine unit. Find a location where you have
approximately 20 ft of working space near the reservoir
that the machine will be put in (The less distance you
have to move the fully assembled machine, the better).
Follow these steps to prepare the machine before
floating it in the water:
©2022 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | [email protected]
Equipment Assembly
458_10264_20220110
O&M_SB5000PW_10272_20220119 - 17
