Turnbuckle Assembly
NO TOOLS REQUIRED:
STEP 1:
Locate the three turnbuckles, M12
90mm Bolts, M12 55mm Bolts, and Nylok
Nuts.
STEP 2:
Notice that the turnbuckle assembly
has an end with a smooth shaft and the other
end with threaded shaft.
STEP 3:
Take the threaded shaft end of
the turnbuckle assembly and slip it into the
Triframe of the core unit assembly. Align
the holes and slide the M12 55mm Bolt into
position and tighten the Nylok nut.
STEP 4:
Once the upper part of the
turnbuckle assembly is in place, take the
opposite end of the turnbuckle and slide it into
the float arm assembly as shown in picture.
STEP 5:
Align the hole through the shaft with
the float arm assembly holes and slide the
M12 90mm Bolt and tighten the Nylok nut.
STEP 6:
Repeat steps 2 through 5 for each
turnbuckle assembly.
• • • IMPORTANT
• • •
Hold the center of the turnbuckle assembly and turn both ends all the way into the
center. Skipping this step will cause decreased extension of turnbuckle and more
time to install may be required.
©2022 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | [email protected]
Equipment Assembly
458_10264_20220110
O&M_SB5000PW_10272_20220119 - 20