STEP 1:
Locate one end of the hose section and place hose clamp over the end, and insert a hose flange.
Repeat on opposite end of the hose section. Be sure that hose and clamp are installed above the metal rib of
the flange and then tighten hose clamp as tight as possible to firmly secure hose.
STEP 2:
If multiple sections of hose are required, repeat step 1 for each section of hose. Fasten the hoses
together by bolting two flanges using four M8 x 20mm bolts.
STEP 3:
Fasten one end of the hose assembly to bottom of top frame securing the flange to the top frame
using four M8 x 20mm bolts.
STEP 4:
Fasten opposite end of the hose assembly to the intake box using four M8 x 20mm bolts.
STEP 5:
Fasten the two intake box tubings using two M8 x 45mm bolts on each tube.
TOOLS REQUIRED
5/16” Nut Driver for Hose Clamps
13mm Wrench and Socket Wrench
Hose Intake Assembly
©2022 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | [email protected]
Equipment Assembly
458_10264_20220110
O&M_SB5000PW_10272_20220119 - 24
