Iwatsu SY-956, Инструкция по эксплуатации

Страница: 29 / 44

19
■
4.6 Attaching and detaching a B Coil
● The following is the method of attaching and
detaching a B coil.
(1) Hold the cover handle and open the cover of this
instrument.
LEDs on the RELEASE button and SET button
blink.
(2) When attaching the provided B Coil 01 or 02, insert
the plug of the B Coil into the B Coil jack and push
the four edges of the B Coil from above so that it
touches the B coil holder (See Fig. 4-10).
When detaching a B coil, gradually lift up the top
and bottom corners of the B coil alternately as
shown in Fig. 4-11 and Fig. 4-12.
(3) When attaching a B coil wound by a user, connect
the front and the end of turns to the S1 and S2
terminals. Use a pair of tweezers for easier wire
insertion into the S1 and S2 terminals.
* Place the excess wire in the concavity of the press
block to prevent interference with the press block
and the measuring yoke when the slider moves up
and down.
* Do not modify the provided B coils . Modifying it
may cause a failure or damage. The warranty is
void if failure or damage occurs. Repair requests
cannot be accepted.
* Do not connect a B coil wound by the user to the
B coil jacks.
Doing so may cause a failure or
damage. The warranty is void if failure or damage
occurs. Repair requests cannot be accepted.
* If the left and right of the B-H curve are reversed,
switch the wires connected to the S1 and S2
terminals.
(2) Gradually press the 4 edges
of the B Coil from above.
Fig . 4-11 Detaching a B coil
Fig. 4-12 Detaching a B coil
(2) Gradually lift the bottom corners
of the B coil with your index fingers.
(2) Gradually lift the top corners of
the B coil with your index fingers.
Fig. 4-10 Attaching a B coil