Iwatsu SY-956, Инструкция по эксплуатации

Страница: 21 / 44

11
Chapter 3 Names and Functions of Each Part
■
3.1 Front panel
Fig. 3-1 Front Panel of SY-956
(1) Main power switch
Main power switch of a Mini Single Sheet Tester SY-956.
(2) Slider position No. table
From the thickness of the sample sheet and the desired force with which the slider presses the sample,
determine the setting value of the slide position No. switch, according to the slider position No. table or the
formula written below the table.
* The load value on the table is the typical value. ±3 [N] deviation from the displayed value may occur.
(3) Slider position No. switch
Set the value determined in (2) which corresponds to the force with which to press the sample. Adjust the
setting value by pressing the buttons above and below the switch.
The valid setting value is from 1 to 16 . Any
other number is invalid.
(4) RELEASE button
Pressing this button when the LED is off will cause the slider to lift up while the LED blinks. When the slider
rises all the way up, the LED stays on and the sample can be detached. Operation is invalid if the button is
pressed while the LED is blinking.
(5) SET button
Pressing this button when the LED is off will cause the slider to move down while the LED blinks and press a
sample with the pressure corresponding to the setting value of the slider position No. switch. When the slider
stops at the correct pressure, the LED stays on. Operation is invalid if the button is pressed while the LED is
blinking.
Pressing the button again, while the LED is on, after changing the value of the slider position No. switch will
readjust the slider to press the sample with the new setting value.
(6) Cover handle
Use this handle to open and close the cover. Push the cover in until you hear a clicking sound. The RELEASE
button and the SET button blink when the cover is open, and blinking stops when closing.
(7) ALARM LED
The ALARM LED turns on or blinks when there is something wrong with the slider. Contact the service
center if the ALARM LED is still on or blinking after restarting.
* It is normal to see a short blinking when the main power is turned on/off.
(1) Main power switch
(3) Slider position No. switch
(7) ALARM LED
(4) RELEASE button
(5) SET button
(2) Slider position No. table
(6) Cover handle