IVT CHS-1600, Инструкция по эксплуатации и безопасности

Страница: 9 / 52

9
Manual instruction | Electric chain saw
EN
Service and preventive
maintenance
Before performing maintenance or tool
replacement unplug the power cord.
Note: Regularly performing the following tasks will
ensure long and reliable tool operation. For safe and
proper working, always keep the machine and the
ventilation slots clean.
The tool should be surveyed on a regular basis •
for revealing visible defects, for example loose or
damaged saw chain. loose fixture and the worn out
or damaged parts.
Check serviceability and correctness of •
installation of all casings and protective covers.
Before use of the tool all required repairs and
maintenance service works should be carried out.
Replacement the Saw Chain / Turning the Guide
Bar Over
The condition of the saw chain and guide bar •
(7) should be checked according to the section
“Tensioning the Chain”.
Over time guide bar (7) gets worn. When •
changing the saw chain, guide bar (7) should be
turned 180° to compensate for wear.
Check the condition of chain wheel (23). If it •
appears to be damaged or worn after heavy work it
should be changed by an expert service center.
Sharpening the Chain
Qualified saw chain sharpening may be carried •
out at any authorized IVT service center.
Checking the Automatic Lubricating Mechanism
The operation of the automated chain lubricating •
mechanism may be checked as follows:
Turn on the machine and hold its end over a •
piece of cardboard or paper placed on the ground.
WARNING: • do not touch the ground with the
chain, maintain a safe distance of approximately 20
cm. If the cardboard or paper shows an increasing
amount of oil the automatic lubricating mechanism
is working correctly. If, however. despite a full oil
reservoir, no oil traces are produced, eliminate
malfunctions by following the instructions under
“Problems and Solutions” or consult an IVT service
center.
Cleaning and storage
The tool’s exterior surfaces should be cleaned •
with a soft brush and cloth. Do not use water,
solvents or polishing compounds. Remove all dirt,
especially out of ventilation slots (10) of the motor.
Do not allow the machine handles to be covered •
in oil.
After 1-3 hours of work, remove casing (4), •
dismantle guide bar (7) and chain (6) and clean
them using a brush.
Clean all dirt from the area under casing (4), •
chain wheel (23) and the mount fitting for guide bar
(7) using a brush.
Clean oil jet (21) with a cloth. •
If the machine is to be stored for a prolonged •
period of time, drain the oil from the oil reservoir,
place chain (6) and guide bar (7) in an oil bath for a
short time and then wrap them in oiled paper.
The tool shall be stored in the dry premise, with •
no access for children. Do not lay any items onto the
tool.
Troubleshooting
The list below offers troubleshooting
recommendations.
Caution: Before troubleshooting switch
the tool off and unplug the cable.
Motor does not start
The shock brake has been activated •
►
Turn the
chain brake initiator to position 1
Power supply is absent •
►
Check power supply
The outlet is defective •
►
Try another outlet,
replace the outlet if necessary
The extension cord is damaged •
►
Check the
cable, replace if necessary
Motor shuts down
The extension cord is damaged •
►
Check the
cable, replace if necessary
Loose outer contact •
►
Contact IVT service
center
Loose inner contact •
►
Contact IVT service
center
Switch malfunction •
►
Contact IVT service
center
Dry Saw Chain
There is not enough oil in the oil reservoir •
►
Top
up oil
The ventilation slots in the oil reservoir are •
clogged up
►
Clean the oil reservoir
The oil output channel is clogged up •
►
Clean
the oil output channel