
A-16
APPENDIX A - DAILY PASSENGER TRANSPORT
D
AILY
Base - 02/2012
Printed 603.95.241
Road tests
Road tests
A.7
Road tests
a)
The following checks must be performed, with the vehicle stationary, prior to beginning functional testing:
•
tyre pressure;
•
oil level in the engine, gearbox and axle, brakes and steering, water in the cooling tank, state of the batteries and level of battery
fluid;
•
operation of the parking brake;
•
operation of the doors, sensitivity of the emergency buttons, control lights, windscreen wipers, windscreen washers, horn,
outside lights, switching off engine from the cab;
•
alignment of the bodywork with respect to the chassis and suspension heights;
•
absence of interference in the steering controls, in the whole path of the rotations of the steering wheel and of the wheels;
•
visibility and correct operation of the indicating lights and acoustic warnings.
b)
The following parameters must be verified during a 50 km drive over various roads (level ground, curves, uphill, downhill and
uneven surface):
•
absence of vibrations or unusual noises due to gearbox, axle, transmission or other assemblies of the chassis or bodywork;
•
correct operation of the mechanical gearbox;
•
gradual braking and absence of excessive force on the pedal;
•
gradual clutch operation;
•
gradual steering without resistance or jolts, maintaining the direction of the vehicle without continuous corrections.
With regard to ”system” function, it should be verified that:
•
no fault message appears on the instrument panel and no danger or warning signal remains lit which should not be present;
•
the electric retarder has a short reply time and determines a gradual action in each point of operation;
•
the speed limiter does not cause jolts;
•
the operation of the emergency button stops the engine, activates the warning and deactivates the batteries;
•
the speedometer is sealed;
•
the heating and air conditioning are efficient;
•
internal and external noise levels comply with the regulations;
•
there are no infiltrations during and after passing through an arch simulating rainwater/washing with a pressurised jet.
With regard to ergonomics, the following should be verified:
•
travel, stiffness, any interference of the gear levers with the dashboard and seat;
•
position, adjustment of leg distance and backrest of the driver’s seat;
•
any visual interference of the steering wheel with the instrument panel and the brightness and lighting of the instrument panel.
c)
On completion of the route, it is necessary:
•
check for any leaks of water, oil, fuel and brak, steering and clutch fluid;
•
Check and retighten the wheel nuts to 290-350 Nm.
Содержание DAILY M.Y. 2012
