ITV SPIKA MS 1000, Руководство по обслуживанию

Страница: 12 / 42

SERVICE MANUAL SPIKA SERIES
12
Damages due to the lack of maintenance and cleaning operations are not included on the
warranty.
3.2. Start-Up
Once the installation instructions are followed (ventilation, site conditions, temperatures, water
quality, etc.), proceed as follows:
1.- Open the water inlet. Verify the no existence of leakages.
2.- For under counter models open the door and remove the protection elements on the shield.
For modular models remove the two locking screws on top of machine, take off the front panel
and remove protection elements on the shield and also on the thickness sensor.
3.- Verify that the shield moves freely. For modular models verify also the thickness sensor
moves freely.
4.- Connect the machine to the power supply.
5.- For under counter models: push the blue switch on the machine front side. For modular
models: push the blue switch found on the back of the machine and then set the ice-wash
switch to the position I.
6.- Verify that there are no vibrations or frictions on the elements.
7.- Verify that the water fall to the evaporator is occurring uniformly and all ice cubes are
properly watered.
8.- Close door (for under counter models) / Replace the front panel in its place (for modular
models).
9.- Verify that after the final cycle, the frost on the aspiration pipe is at 0.78 in (20 mm) of the
compressor.
10.- For modular models: Verify the ice slab with the pictures below. In case the thickness
sensor needs to be regulated, rotate the thickness adjustment screw CW to increase bridge
thickness. Rotate CCW to decrease bridge thickness. For under counter models adjust the cycle
thermostat.
Thickness
sensor