ITV SPIKA MS 1000, Руководство по обслуживанию

Страница: 6 / 42

SERVICE MANUAL SPIKA SERIES
6
2. INSTALLATION
2.1. Placing of the ice maker
This ice maker is not designed for outdoor operation. The icemaker should not be located next
to ovens, grills or other high heat producing equipment.
The SPIKA machines are designed to operate at room temperature between 41ºF (5ºCF) and
109.4ºF (43ºC). There may be some difficulties in ice slab removal under the minimum
temperatures. Above the maximum temperature, the life of the compressor is shortened and
the production is substantially lower.
The air cooled SPIKA NG (under counter) ice makers take the air through the front section, and
drive it off through the lateral, back and also front louvers due to their new oblique condenser
structure and placement. Do not place anything on the top of ice maker or facing the front grille.
In case the front grille is either total or partially obstructed, or due to its placement it receives hot
air from another device, we recommend, in case it is not possible to change the location, to
install a water-cooled machine.
The air cooled SPIKA MS (modular) ice makers take the air through the back section and drive
it off through the two lateral louvers. In the case it is not possible to respect the minimum
distances recommended (see the picture in point 3.3) for these machines we recommend
installing a water-cooled unit.
The location must allow enough clearance for water, drain and electrical connections in the rear
of the ice machine. It is important that the water inlet piping does not pass near sources of heat
so as not to lose ice production.
2.2. Leveling of the ice maker
Use a level on top of ice machine to ensure the equipment is perfectly leveled.
Screw the leveling legs onto the bottom of the ice machine as far as possible.
Move the machine into its final position.
Use a level on top of the ice machine. Adjust each leg as necessary to level the ice machine
from front to back and side to side.
ATTENTION: There is an optional 3 ½'' (=90mm) high casters kit that can be used in
substitution of the standard legs. These wheels are supplied with the corresponding installation
instructions.