5
L=2
xS+H+208
80
S
H
S
64
64
20
80
On longer stretches, when the support profiles have already been installed
or are being held in a vice and the Shaft-Clamp Profile has been pressed into
place, you can press the shaft into the Shaft-Clamp Profile section by section
using the Mounting Aid (0.0.265.38) and a lever in the form of a suitable
round steel bar.
Installation
Support profile,
e.g.: Profile 5 60x20
Guide,
e.g.: Roller guide 5 D6
Drive,
e.g.: Timing Belt R10 T5 and Timing-Belt Reverse Unit 5 40 R10 with Bore
Fundamentally, a Linear Unit converts a rotary motion into a translational
motion.
A Linear Unit is made up of:
▪
Guide
▪
Drive
▪
Support profile
These components are picked for assembly and assembled in part or in full,
depending on customer wishes.
Preparation
Shaft-Clamp Profile and Shaft:
There are various methods for assembling support profile, Shaft-Clamp Profile
and Shaft.
To make installation easier, apply a film of oil or grease to the outer surfaces of
the Shaft-Clamp Profile that come into contact with the support profile before
pressing it into the groove. Do the same to the contact points between the
Shaft and Shaft-Clamp Profile and to the guiding Shaft itself. When working
with short support profiles that have not yet been connected to a fixture, it is
advantageous to undertake installation in the following steps:
▪
Press the Shaft-Clamp Profile into the relevant groove of the support profile
▪Use a vice (fitted with protective jaw plates) to press in the Shaft
▪
Follow the same sequence for the other side
