Isokern Magnum 28, Инструкция по установке, эксплуатации, обслуживанию и руководство владельца

Страница: 25 / 72

25
Assembly Instructions - 60” (cont.)
Step 20:
Set the smoke dome sloping side walls, part 34, in
place between the front and back smoke dome arrangements
at their proper locations at each end of the smoke dome.
(Figure 42).
The overall width dimension at the top of the smoke
dome should be approximately 53-1/2 to 54”. (Figure 43)
Note:
The MAGNUM model 60 is designed to operate
with two flues. The top of the smoke dome allows for the
placement of two Isokern Modular Masonry DM 54 (14 inch
I.D.) chimneys or two solid fuel listed metal chimneys of the
appropriate size.
Step 21:
Smoke dome top plate small, part M77, two required,
must field cut to fit.
Each of the two smoke dome top plate small, part
M77, will sit side by side on the smoke dome assembly,
meeting at the centerline of the smoke dome as a butt joint.
The top plate, as standard, comes with a recessed edge (or,
a thickened center). The recessed edge is approximately
3/8”and is intended to be the bottom face of the top plate.
Each of the two top plate pieces must first be cut in
width in order to fit the overall smoke dome. Each top plate is
to have its width cut by 5”. The cut edges must then become
the butt joint of the two top plates when set into place
(Figure 44). Therefore, the width cuts for each top plate must
be on opposite edges of each piece.
The un-altered end of each top plate sits at the end
of the smoke dome assembly and rests on the smoke dome
sloping side wall.
At the recessed edge on the underside of the
un-altered ends of each of the two top plates, the thickened
part of the top plate will need to be ground down flush with
the recessed edge of the top plate so that the underside of the
top plate does not ride high on the smoke dome sloping side
wall.
Place the two top plate small components on top of
the second tier smoke dome arrangement so that they meet at
the centerline of the smoke dome.
The outlet hole sits closer to the back of the smoke
dome. The smoke dome top plates should sit flush with the
front and back of the smoke dome.
The top width dimension of the completed smoke
dome should measure approximately 53 1/2”- 54”. Each top
plate small has a width cut dimension of approximately 27”.
Two of the top plates butted together should equal the smoke
dome top width dimension of approximately 54”.
The top plates may have some overhang at the ends
of the top plate assembly, which is acceptable. (Figure 45)
FIGURE 43
FIGURE 44
FIGURE 45
53½”
5”