Isokern Magnum 28, Инструкция по установке, эксплуатации, обслуживанию и руководство владельца

Страница: 19 / 72

(NO GAPS)
FIRE BRICK FLOOR
1/2" GAP
EXPANSION
(BUILT FIRST)
1/2" GAP
EXPANSION
FIRE BRICK
FLOOR AND
BACK WALL
(BUILT FIRST)
19
Assembly Instructions - Fire Brick Installation
Fire Brick Installation:
The manufacturer requires that the MAGNUM
Series fireplace firebox be lined with a minimum one and
one-eighth (1-1/8”) thick rated fire brick. The pattern for the
fire brick lining is an owner option. Standard N or S -Type
brick mortar is a suitable mortar for the fireplace. Add a small
portion of Earthcore mortar to make it a sticky consistency
with a 1/4” notch trowel bed joint. Because of different
climates, the use of good masonry practices for your area
should also be considered.
All required through-wall accesses (gas and
electrical line feeds and combustion air supply access holes)
should be drilled before the required fire brick lining is
installed.
It takes a total of about five gallons of brick mortar
mix (dry measure) to fire brick line a MAGNUM fireplace.
Face joints of one quarter inch (1/4”) to three-eights
inch (3/8”) give a good appearance to the finished brickwork
however, this is just a suggestion and other face joint
dimensions are also acceptable.
Step 1. Wet mop the inside of the MAGNUM fireplace with
a damp sponge to remove dust and loose particles from the
interior before installing fire brick.
Step 2. Start the fire brick at the front edge of the floor of the
Isokern firebox, proceeding inward toward the back.
HINT:
Dip each firebrick into water before applying.
Step 3. Next, apply fire brick to the back wall of the unit
starting at the bottom of the back wall and working upward to
the top of the back wall.
Step 4. Finally, set the side wall fire brick by starting at the
front edge of the unit’s side wall and working inward toward
the back wall fire brick.
NOTE: The 60 & 72 units require 4” Fire-Brick on the
side walls.
Isokern makes no claims as to the performance
of fire brick or fire brick mortar(s). It is typical for heat
stress cracks to appear in the fire bricks in wood burning
fireplaces.
FIGURE 24
FIGURE 23
FIGURE 22