Iseki TG5330, Руководство по эксплуатации

Страница: 97 / 176

TG5330,5390,5470
96
Attaching Implements
CAUTION: Always use POSITION CONTROL
to attach/detach implements to provide pre-
cise control of hitch.
FIG. 5-76: Back Tractor to implement, centering Tractor
with implement hitch frame.
Raise or lower hitch using position control lever, 1, and
align left lower link end with corresponding implement
attaching pin.
Lock the brakes, shut off engine and remove key.
FIG. 5-77: Slide ball end of left lower link, 1, over imple-
ment pin and secure with linch pin.
Adjust height of right lower link using leveling crank,2.
Attach and secure right lower link, 3, to implement with
linch pin.
Attach top link, 4, to top of implement hitch frame using
pin supplied with Tractor. Rotate center barrel section of
top link, to lengthen or shorten it, and level implement
from front to rear.
After the implement is attached, it can be readjusted for
level operation using turn buckle and top link. Secure all
adjustments.
IMPORTANT: With some mounted implements, it will be
necessary to remove drawbar at rear of
Tractor to permit implement to be raised
and lowered without obstruction.
FIG. 5-78: Certain implements require minimal side-play.
Check chain 1, at each lower link should be evenly adjust-
ed to reduce side-play to desirable level. Do not remove
all side-play as lower link damage may result.
NOTE: The amount of side-play (stabilizer looseness) is
dependent upon implement and type of operation.
Normally 2 (50mm) of total side movement is
desired, 1 (25mm) to each side of Tractor center-
line.
FIG. 5-76
3
4
1
2
FIG. 5-77
FIG. 5-78