Iseki TG5330, Руководство по эксплуатации

Страница: 44 / 176

43
Coolant Temperature Gauge
FIG. 4-36: Gauge, 4, indicates engine coolant tempera-
ture when main switch is selected to ON
・ - Shows too cool temperature for severe work.
Allow to warm before applying heavy load.
・ - Indicates overheating Reduce engine speed to
idle, allow to run at no load several minutes and
investigate cause (refer to Troubleshooting ).
CAUTION: Do not service hot engine. Allow to
completely cool before servicing or removing
radiator cap.
Tachometer
FIG.4-37 & 4-38: Scale,5, indicates engine speed in
crank shaft revolutions per minute(rpm). Digital panel
indicates not only engine revolutions but also traveling
speed, rear PTO speed, mid PTO speed, hourmeter, trip
meter.
Indication of degital panel is changed by pushing selec-
table switch,6.
When rear PTO speed is 540, engine revolutions is
approximately 2430 rpm.
Normally, the PTO speed should be between 540 and
600. Operating the PTO at a speed above 600 is too fast,
and may result in breakdown of the tractor or implement.
Hourmeter is used to assist in maintenance intervals of
tractor. The extreme right digit indicates 1 hour incre-
ments.
Tripmeter is used to assist in your operation. The extreme
right digit indicates 1/10 hour increments.
INSTRUMENTS & CONTROLS
5
FIG. 4-37
6
FIG. 4-38
4
FIG. 4-36