Iseki TG5330, Руководство по эксплуатации

Страница: 129 / 176

128
TG5330,5390,5470
FIG. 6-10: Transmission filter,4, for power shuttle model
shown. With oil drained, unscrew filter from adapter (filter
wrench may be required).
Clean adapter and lubricate seat on new filter. Install until
filter gasket contacts adapter and tighten additional 2/3
turn, by hand. Do not use filter wrench to tighten.
Front Axle Oil (4-WD Only)
Front drive axle has a common oil level for front differen-
tial housing and each wheel reduction unit. Oil level
should be checked every 200 hours of Tractor operation.
The oil should be changed every 600 hours of
operation(indicated on Hourmeter).
FIG.6-11a: TG5330:S/N~000060
TG5390:S/N~000145
TG5470:S/N ALL
To Check Oil Level
―
Park Tractor on level ground and
then remove oil level plug,1. Oil should be level with or
slightly below level plug opening. Remove fill plug,2, and
add oil until oil is expressed from level plug opening.
Replace level plug and fill plug.
To Change Oil
―
Remove drain plug,3, from both wheel
reduction units. When all oil has drained, replace drain
plugs and fill housing to level plug opening. Replace level
plug and fill plug.
FIG.6-11b: TG5330:S/N 000061~
TG5390:S/N 000146~
To Check Oil Level ― Park Tractor on level ground and
then remove fill plug,2. Oil should be level to top of the
shaft. Add oil to top of the shaft. Replace fill plug.
To Change Oil
―
Remove drain plug,3, from both wheel
reduction units. When all oil has drained, replace drain
plugs and fill housing to top of the shaft. Replace fill plug.
Checking/Replenishing Coolant
Fig. 6-12: The radiator is provided with a reserve tank, 1,
to maintain the coolant in the radiator at the proper level.
Check the level in this reserve tank during the daily
inspection.
Open the hood, and confirm that the coolant in the
reserve tank is between FULL and LOW.
If the coolant level is low, add coolant to the reserve tank
up the FULL level.
4
FIG. 6-10
1
FIG. 6-12
3
1
2
FIG. 6-11a
3
2
FIG. 6-11b