Iseki SF310, Руководство оператора, Страница: 65 / 92

CHAPTER 8. MAINTENANCE
63
e. After replacement, start the engine and let it idle for a
while. Then stop it and wait for a while until the oil
comes down into the oil pan.
Now check the oil level to check to see if it is at the
upper limit or not. When the level is low, replenish until
the level reaches the upper limit.
f. Make sure that there is no oil leaking through the oil fil-
ter, suction filter, rubber hoses, or drain plug.
22. HYDRAULIC OIL FILTER
IMPORTANT:
•
The hydraulic oil filter should be replaced after the ini-
tial 50 hours of operation and then after every 300
hours of operation. It should also changed every time
the transmission oil is replaced.
• It is recommended to ask your dealer to replace the
hydraulic oil filter. But when there is no alternative but
to replace the filter by yourself, observe the following
instructions.
The hydraulic oil filter,1, is located center of the right-hand
side of the front mower.
a. After the transmission oil has drained out completely,
remove the filter using the filter spanner.
When removing the filter, a small amount of oil may
spill, so place waste cloth under the filter to receive
spilt oil.
b. Apply thin coat of oil to the O-ring of the new oil filter
cartridge ahead of time. Then install the filter. Screw in
the filter by hand until the rubber packing comes into
contact with the sealing surface, and then screw in it
by a 2/3 turn with the filter spanner.
Oil: SHELL DONAX TD oil
23. SUCTION FILTER
IMPORTANT:
•
The suction oil filter should be cleaned after the initial
50 hours of operation and then after every 200 hours
of operation. It should also cleaned every time the
transmission oil is replaced.
• It is recommended to ask your dealer to replace the
suction filter. But when there is no alternative but to
replace the filter by yourself, observe the following
instructions.
The suction filter,1, is located bottom left of the transmis-
sion case.
(1) Hydraulic oil filter
(2) Rubber hose (3) Suction pipe
(4) Hose clips
1
FIG. 101
Transmission oil
Capacity
SHELL DONAX TD
17 liters (3.7 imp-gal.)
2 4
3
FIG. 102