CAUTION!
Caution!
When installing the units, make sure that an air flow through the corresponding air inlet and outlet openings is
possible.
CAUTION!
Caution!
A specified air flow rate (see
) has to be guaranteed under any circumstances.
The air inlet and outlet openings must not be covered or obstructed.
CAUTION!
Caution!
For devices equipped with a LEMO high voltage connector (L16, L30), the high voltage must not be switched on
until the corresponding counterpart has been contacted.
CAUTION!
Caution!
The GPS 350 - COMPACT device is prepared for installation in a device carrier. The fixing points on both sides
can be used for this purpose.
The screw-in depth of the M4 screws used for fastening must not be more than 4 mm, measured from the
housing surface.
If the device is used as a desk top instrument, the enclosed distance pieces have to be installed at the bottom
side of the device.
The unit may only be operated at this minimum distance (10 mm) from the stand surface.
INFORMATION
INFORMATION
The shield of the high voltage output is always connected to the housing and can be used as a return
conductor.
INFORMATION
INFORMATION
It is strongly recommended to read the manual before operation!
GPS High Voltage Power Supply Series | Last change: 10.01.2020 |
www.iseg-hv.com
7/40