11 Restoring factory defaults
To reset the device to factory settings:
1. Press and hold RESET button for 10 to 15 seconds
2. Green LED will start flashing 2 times a second (Nano Relay Output), the display
will show:
rSt
(Nano Relay Output PoE).
3. Release the reset button.
With factory defaults restored the module settings are as follows:
•
DHCP: enabled
•
IP address: 192.168.111.15
•
IP mask: 255.255.255.0
•
User name: admin
•
Password: admin00
12 Firmware update
The device has the ability to update the firmware. The software update program is
provided as a *.bin file.
Warning!
Incorrect use of the update feature may damage the reader. Make sure that
undisturbed power is provided to the device for duration of programming.
To update the software:
•
check the
Enable TFTP Bootloader
option, which is located in the Administration
tab,
•
run the Windows command line (Start-> Run enter 'cmd' and confirm with the
Enter key),
•
go to the directory where the .bin file is located
•
enter the command:
tftp
-i <address_ip_of the reader>
PUT
file.bin
where: <address_ip_of the reader> is the IP Address of the reader
file.bin – the file with the update program
Programming takes 1-2 minutes. End of programming confirms the message 'File
Transferred'.
For correct functioning of the reader, after the update operation the „
Enable TFTP
Bootloader
” option has to be switched off.
Step-by-step instruction for firmware updates is available at
.
The latest instructions and software are available on the site
.
User manual Nano Relay Output PoE / Nano Relay Output
Page
29
of
29
[B02a]
