8 Communication with the module from the external network
If the module is in a different LAN network than the computer connecting to it, port
forwarding is required.
Depending on the communication method used with the module, it is necessary to
contact the Network Administrator and port forwarding:
Support via website and HTTP protocol:
- port TCP 80
Service by a computer program or by your own application:
- port TCP 9761
Support via MODBUS TCP
:
- port TCP 502
Support via SNMP protocol
:
- port UDP 161
9 Checking the IP address
To check the current IP address of the device (Nano Relay Output PoE only):
1. Press and hold the reset button until the display shows the four parts of the IP
number, e.g.
192 168 111 15
.
2. Release the reset button.
10 DHCP
To enable/disable DHCP service:
1. Press and hold RESET button 5 to 10 second.
2. Green LED will start flashing 2 times a second (Nano Relay Output), the display
will show:
dhcP
(Nano Relay Output PoE).
3. Zwolnić przycisk RESET.
It is also possible to enable DHCP in the network configuration in the
Network
tab or
through
Discoverer
application.
User manual Nano Relay Output PoE / Nano Relay Output
Page
28
of
29
[B02a]
