SECTION 13—RECLINER BACK OPTION
Part No 1125027
79
Solara
®
/Spree GT
™
Adjusting the Recliner Cables
NOTE: For this procedure, refer to Adjusting the Gas Cylinders on page 83.
Replacing the Recliner Cables
NOTE: For this procedure, refer to FIGURE 13.3 on page 81.
NOTE: For ease of assembly, replace one recliner cable at a time.
Removing Existing Recliner Cables
1. Cut the tie wraps that secure the recliner cable to the back cane.
2. Remove the mounting screw and the locknut that secures the recline trigger release
lever to the back cane.
NOTE:
Save the mounting screw and locknut for reuse when installing the new recliner
cables.
3. Remove the recline trigger release lever from the back cane.
4. Loosen the cable locking nut that secures the recliner cable to the recline trigger release
lever (Detail "A")
5. Unscrew the cable locking collar that secures the recliner cable to the recline trigger
release lever (Detail "A").
6. Remove the end of the recliner cable from the slot in the recline trigger release lever
(Detail "A").
7. Unscrew the fitting end of the recliner cable from the recline trigger release lever
(Detail "A").
8. Unscrew the cable locking nut that secures the recliner cable to the actuator housing
(Detail "B").
9. Remove the end of the recliner cable from the actuator.
10. Remove the recliner cable from the wheelchair.
Installing New Recliner Cables
1. Screw the recliner cable into the recline trigger release lever until the fitting end of the
cable is flush with the inside of the handle (Detail "A").
2. Install the end of the recliner cable into the slot in the recline trigger release lever
(Detail "A").
3. Screw the cable locking collar onto the trigger release lever until the collar bottoms out
on the trigger release lever (Detail "A").
4. While holding the cable locking collar and locking nut, tighten the cable locking nut
against the cable locking collar (Detail "A").