SECTION 9—TILT
Part No 1125027
61
Solara
®
/Spree GT
™
SECTION 9—TILT
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Engaging Tilt-In-Space
WARNING
The Invacare Solara wheelchair MUST be operated by an Assistant when in ANY
tilted position.
ALWAYS make sure that the wheelchair is stable before using the tilt-in-space.
Rear wheels may have to be repositioned rearward depending on the degree of tilt-
in-space required. ALWAYS ensure stability before using maximum amount of tilt-
in-space. TEST wheelchair before it is occupied by the end user to ensure safety.
DO NOT self propel wheelchair while in the tilted position.
ALWAYS engage both wheel locks while using the tilt-in-space.
NOTE: For this procedure, refer to FIGURE 9.1.
NOTE: To lower the seat parallel with the floor, reverse the following procedure.
1. Place the wheelchair on a level surface.
2. Engage both wheel locks.
3. Inform the occupant of the wheelchair that the wheelchair is about to be tilted and
remind them to lean back.
4. Make sure the occupant's hands and body are clear of all pinch points.
5. Perform one of the following:
A. For Hand Operated Tilt (Detail “A”):
a. Stand behind the wheelchair and grasp both back canes firmly.
b. Pull up on the trigger release levers to release the tilt mechanism from the tilt
slide.
c. Slowly, push down on the back canes while pulling up on the trigger release
levers in a continuous motion.
d. When the seat reaches the desired angle, slowly let go of the trigger release
levers.
B. For Foot Operated Tilt (Detail “B”):
a. Push down on the foot lever to release the tilt mechanism from the tilt slider.
b. Slowly, push down on the back canes while keeping the foot lever depressed.
