Settings and Adjustments
1.
Remove the width adjustment plates.
2.
Remove the screws on the front and remove the front
and back plates. The shaded areas indicates where
drilling can be done. Max. diameter of drill hole is 6
mm. Use washers with the minimum 18 mm diameter
beneath the nut on the inside of the screws.
3.
Return the parts, re-insert the screws and tighten them
with 3,2 Nm.
3.3 Tension adjustable backrest
3.3.1 Adjustment height — tension adjustable backrest
There are two ways of adjusting the height for the tension
adjustable backrest:
Height adjustment — alternative 1
You can easily adjust the tension adjustable backrest (max.
+120 mm).
A
1.
Loosen the four screws
A
as shown above.
2.
Set at the required height.
3.
Re-tighten the screws.
Height adjustment — alternative 2
A
B
C
D
A
to
D
Screws for alternative height adjustment
Tools: 5 mm Allen Key
An additional height adjustment can be made by mounting
the backrest attachment either in position
A
and
C
or in
position
B
and
D
on the backrest tubes, as shown in the
picture above.
0
1
2
3
4
0
1
2
3
4
0
1
2
3
4
0
1
2
3
4
A
B
C
A
Tools: 5 mm Allen Key
1.
Remove the screws and the washers
A
, the long nut
B
,
and the backrest attachment
C
.
2.
Support nut
B
, screws and washers
A
in order to
prevent them from falling to the ground.
3.
When the position of the backrest attachment
C
is
changed, re-mount everything and tighten the screws.
3.3.2 Width adjustment — Tension adjustable backrest
Risk of damage
Poor functionality on the backrest.
– Any adjustments made to the backrest should
be evaluated by trained personnel.
The tension adjustable backrest must be adapted and
adjusted according to the individual needs of the user. The
following steps guides you through the adjustment of the
backrest.
Turning of the backrest tubes
The tension adjustable backrest is designed with different
angles as shown in picture
A
and
B
below. This allows
1572308-G
25
Содержание REA Dahlia 30
Страница 51: ...Notes...
