Rea® Dahlia® 30 / 45
1.
Loosen and remove the screw
O
.
2.
Remove the tilt handle
N
from the attachment
M
.
M
R
P
Q
M
S
Standard armrest pad
Straight narrow armrest
pad
3.
Mount the tilt handle attachment
M
on the armrest pad.
4.
If the standard armrest pad is used, attach the metal
washer
P
and the screw
Q
between the armrest pad
and the attachment
M
. Tighten with 2,5 Nm.
5.
Attach the screws
R
or
S
depending on the armrest
type and tighten with 2,5 Nm.
N
O
N
O
Standard armrest pad
Straight narrow armrest
pad
6.
Mount the tilt handle
N
on the tilt handle attachment.
7.
Tighten the screw
O
.
•
Screwdriver PH2
•
Torx driver T20
T
U
8.
Attach the clip for the wire
T
in the upper corner of
the side guard.
9.
Place the wire
U
in the clip holder.
V
X
W
10. Loosen the screw
V
in order to remove the lever for
the hand operated tilt
W
.
11. Loosen the nut to the brake wire for the tilt handle
X
and remove the wire.
•
Screwdriver PH2
•
10 mm fixed spanner
Z
Y
Y
12. Place the wire from the user operated tilt
Y
as shown
on the picture.
13. Attach the wire to the chassis with an attachment clip.
14. Attach the wire from the user operated tilt
Y
on the
gas piston.
15. Tighten the attachment nuts
Z
.
10 mm fixed spanner
2.12 Reducing tilt and / or backrest recline
Depending on the rear wheel size when the wheelchair is
ordered with a low seat to floor height, reduction bushings
are added to the tilt and/or recline function in some
combinations. This is because there may be a conflict
between the seat frame and the rear wheel attachment
when tilting or reclining the chair. This means that the
operating range of the gas piston is reduced in order to
avoid damage to certain parts when tilting or reclining the
wheelchair. One or more reduction bushings can be used,
each reduction bushing reduces the tilting/reclining range
with 10º. This means that if the tilt/recline have a range of
1–30º, the range will be reduced to 1–20º by adding one
reduction bushing to the gas piston. For the Dahlia 30º
version, the reduction bushings can be used to reduce both
the tilt and the recline range. For the Dahlia 45º version,
the reduction bushings will reduce the recline range with
10º or 20º and the reduction blocks will reduce the seat
tilt range from 45º to 30º.
CAUTION!
Risk of damage
Removing the reduction bushings could cause
damage to the wheelchair in some positions.
– Be careful when tilting/reclining the chair if
the reduction bushings are removed. Read the
instructions concerning limitation areas and
how to avoid them.
See section: “Troubleshooting” for more information.
10
1572308-G
Содержание REA Dahlia 30
Страница 51: ...Notes...
