346
PO
S AVE THESE INSTRUCTIONS
(346PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 08/10/2019
English
Page 9
SET UP (continued)
Infl ation
Infl ate the Spa Tub Wall
1.
Take out the ground cloth
(19)
and spread it over the cleared area. Then spread out the spa liner over
the ground cloth and point the drain valve towards a suitable draining area.
NOTE:
Spread the ground cloth with the bubbles facing down over the cleared area where you intend
to setup your spa.
2.
Flip up the control base side cover
(36)
to reveal the air blower in
fl
ation outlet. Pull out the latch to open
the cover, insert the hose adaptor
(24)
and reattach the latch to the hose adaptor to secure it in place
(see
drawing 3)
.
3.
Attach the large end of the in
fl
ation hose to the hose
adaptor.
4.
Unscrew the air valve cap on the spa tub to reveal the
stem in the up position for in
fl
ation. Insert the other end of
the in
fl
ation hose
(7)
into the valve and turn to the right to
lock it in position
(see drawing 4)
.
5.
Press
the button to turn on the control panel buttons
fi
rst. Press the
button to in
fl
ate the spa tub wall for
8 to 10 minutes until it is
fi
rm to the touch but not hard
(see drawings 5 & 6)
.
IMPORTANT:
Do not over in
fl
ate or use high pressure
air compressor to in
fl
ate.
3
1
2
3
4
5
4
7
1
2
5
