346
PO
S AVE THESE INSTRUCTIONS
(346PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 08/10/2019
English
Page 16
OPERATION (continued)
Function
ON
OFF
Information shown on LED display alternates between
Remaining
fi
lter pump time and water temperature
HSDT
HSOH
Remaining HSDT time and water temperature
HSDT
HSOH
Remaining HSDT/HSOH time and water temperature
HSDT
HSOH
Remaining HSOH time and water temperature
HSDT
HSOH
NOTE:
Keep the spa control panel within 5m (16ft) range of the control base to ensure good
wireless transmission signal.
1) Always keep the spa cover on to minimize heat loss during heating of the spa between
uses (but not while it is being used). Ensure the cover is
fi
tted tightly, as per manufacturer’s
instructions to maximize insulation. It shall be recommended that the cover, when not in
use, should be kept off the ground to retain its cleanliness (particularly the surface in close
proximity to the water spa water surface). The cover should be stored in an appropriate
location, where it cannot be damaged, or cause damage.
2) Check the set water temperature and consider lowering it for the times when the spa will
typically not be in use.
3) Depending on external conditions, consider turning off the heater entirely if not using the spa
for an extended period of time (where the spa provides this option, but still maintains residual
disinfection/pH-values).
4) Consider that the comfortable temperature range during use may be lower than the maximum
safe temperature.
5) Use the included insulating ground cloth underneath the spa to minimize heat loss through
the bottom of the spa.
6) Maintain
clean
fi
lters to preserve appropriate working conditions for the pump and avoid
unnecessary water replacement and re-heating.
MINIMIZE HEAT LOSS AND ENERGY CONSUMPTION ADVICE
