12
with double collar bag
high filtration 5-layer fiber bag.
1.
Remove the front panel on the vacuum cleaner by sliding the latch/lock to the left and remove the front panel
with dust bag attached dust bag. Remove full bag and discard.
2.
Please notice: the #
double sided bag has 2 openings. The collar which attaches in the back of the vacuum
chamber is clearly marked "
PUSH THIS COLLAR OVER PIPE IN THE BACK OF THE VACUUM CHAMBER FIRST
" Hold
the dust bag by the edges of the cardboard in your hand like shown in the
picture #1
below. Push onto the pipe in
the back of the chamber holding at about a 45-degree angle and then push down the lower part of the Collar
against the back wall until flush.
Pic. #2.
3.
Push the front cardboard collar of the dust bag all the way over the pipe on (the front panel.
Pic. #3
4.
Slide the front panel. with the left side first into the small slots on the left side of the vacuums frame,
see Pic's E
and F above.
Ensure dust bag is completely inside compartment, then push the right side into the frame until the
lock/latch clicks into place.
C.4. To change motor filter, replacement Part #
1.
Remove FRONT PANEL with DUST BAG.
2.
On the left side, inside the vacuum chamber. you will see the filter with the arrow pointing towards the back wall.
3.
Replace the filter with a new or cleaned filter, with the arrow pointing towards the back wall check that the filter
stays on the left side in the top and bottom support. If the filter is dirty you can wash in mild soap by hand.
Do not clean in washing machine
. Let filter dry
completely
and reuse as needed.
TROUBLE SHOOTING:
TIP: Model
if you do not have any suction power, but the motor runs:
A) One of the gray hoses connecting the vacuum with a valve came loose or was not connected properly.
B) The slider on the vacuums front panel is not closed.
NOTE: IF MOTOR SUDDENLY STOPS:
1.
The most common cause is a clogged hose. Disconnect vacuum hose from cleaner, hold one end high up in the air
and drop a quarter or similar object into the hose. If the quarter gets stuck the hose is clogged. Try to unclog the
hose with a long stick or see below "cleaning the hose".
2.
The bag is overfilled, or fine dust has clogged the bag. Replace with new bag.
DO NOT EMPTY AND REUSE
3.
The vacuum cleaning tools are clogged.
4.
Vacuuming large amounts of dust other than household dirt, such as dry-wall or fine wood dust can block the
bags pores fast, even if the bag is fairly new.
5.
The motor filter is dirty and should be cleaned or replaced.
6.
If vacuum unit is installed in an airtight compartment the exhausting air cannot escape, the motor can overheat
and shut off until it has cooled down and is restarted, see page 10.
Содержание CS-RM
Страница 9: ...9 Installing dust bag and motor filter...
