5
POWER UNIT
3/8
The central vacuum should be mounted so that power supply cord can be plugged directly
into an electrical outlet.
Choose a place that is centrally located to maximize the reach with the vacuum hose.
The minimum wall thickness is 3/8” the maximum is 1”.
The cut-out in the wall is 11“wide X 6” high and requires 6” depth for
Very important:
If you installed the vacuum in a very small cabinet, you must
m
ake provisions to
exhaust the air from the vacuum out of the cabinet.
Option 1:
Option 2:
Cut a hole in the cabinet a minimum
3”
, attach a louver to cover the hole.
Use our part #AS-61 exhaust fitting with a
2”
diameter flex-hose to guide
the warm air to the outside, or to wherever you prefer. See page 13 options.
Step A.
Step B.
Step C.
Step D.
Tape the paper template against the surface at a comfortable operating height.
With a skill saw cut along the dotted line of the paper template
.
Slide the unit, power cord in first, into the opening and secure by tightening
the four attached screws behind the front panel with the “clamps”.
Do not over-tighten.
Check to be sure dust bag and motor filter are in place.
Содержание CS-RM
Страница 9: ...9 Installing dust bag and motor filter...
