InterVac CS-RM, Инструкция по установке и эксплуатации

Страница: 10 / 13

10
#19 Model CS-RM ; handling and disposing of the double-sided dust bag.
#20 Model CS-RM ; inserting the dust bag, see also page 10 picture 1,2 and 3.
#21 All Models; inserting the front panel into the collar of the dust bag.
#10 All Models; attach the front panel in an angle on the left side first.
DO NOT USE FORCE! Then push slider lock to the right, see arrow.
#23 All Models; removing the motor filter
#24 All Models; sliding the filter back into the slot, note the arrow direction.
HOW TO OPERATE YOUR VACUUM CLEANER
IF THE VACUUM STOPS RUNNING:
If the vacuum hose becomes clogged the motor will shut off. Push the switch into "source"
(Model CS-6) or "off" position (Model CS-8 and CS-RM ) and let the motor cool down for one
hour. Restart the vacuum without the vacuum hose attached and push the slider cover to open
on the front panel, let the vacuum run for about 10 minutes. If vacuum keeps running the hose
or the tools are clogged.
PLEASE SEE TROUBLE SHOOTING GUIDE .
A. Connecting and disconnecting the friction vacuum hose.
1. Push the slider cover on the front panel to the open position.
2. Insert hose cuff with a twist and push to secure.
3. To remove, turn cuff in either direction while pulling hose towards you.
B. On / Off Switch
1. To start the vacuum cleaner, push the switch to the "I" on or "VAC" position depending on your
model.
2. To stop the vacuum cleaner, push the switch to the "O" off or "MICRO / SOURCE" position
depending on Model.
C.1. How to change the Y10 dust bag. DO NOT REUSE DUST BAGS
CS-6 and CS-8 MODELS
with single collar bag
Replacement bag: Part # Y10 high filtration 5-layer fiber bag.
1. Remove the front panel on the vacuum cleaner by sliding the latch/lock to the left and remove
the front panel and dust bag.
2. Carry front panel and dust bag to the trash container. Remove full bag and discard.
3. Push the cardboard collar of the new dust bag all the way over the pipe on the front panel.
Pictures A to C
4. Slide the front panel, with the left side first into the small slots on the left side of the vacuums
frame, ensure dust bag is completely inside compartment, then push the right side into the
frame until the lock/latch clicks into place. With your thumb you might have to push the
lock/latch further to the right.
Picture A Picture B Picture C