11
convection fan speed will also increase with the heat level setting. When the light is
flashing during the start up cycle the heat level button will not respond to the
adjustments. When the light is solid, indicating the start up cycle is finished, it will then
respond (only in manual mode).
Fan:
Use this button to override the automatic fan speed control to turn the convection
fan on high. The smart control on this pellet stove will vary the fan speed in accordance
with the heat level setting. It is recommended to let the controller automatically adjust
the speed of the fan for optimum efficiency and minimal fan noise.
Auger:
Pressing and holding this button will turn on the auger to speed feeding of pellets
into the burn pot, when first using the pellet stove or when you completely empty the
hopper of pellets and restarting after reloading the hopper. You can load the auger faster
by pressing and holding this button (until you see pellets dropping into the burn pot).
This button will turn off after 1 minute and must be released and pressed again if you
want to continue to manually operate the auger.
Auger Trim:
This is used to change the feed rate on the minimum heat level for various
quality of pellet fuel. This will help to keep the flames from extinguishing on the
minimum heat level setting..
Push and release the Auger Trim button once and the heat level 1 and 5 lights appear.
This will slightly increase the feed rate on the minimum heat level setting to keep the
burn pot flames from going out.
Push and release the button until just the heat level 1 setting light is on, this is the factory
setting and works for most types of fuel.
