P/N 466-5519 REV 0.01 • 24MAY19
7 / 14
For Two Stage Heat/Cool Systems:
Go to Advanced Systems Settings menu. From the Setup
menu screen, press and hold the Fan
and Down arrow
buttons for 5 seconds. Use the Down arrow
button
to select the following:
x
AUXHEAT:
If you have auxiliary heat strips, set this to Y
to enable. (Default is Y).
x
2nd Stage Heat Enable:
Enable second stage heating
outputs.
If a single stage heating system, leave this set to N
If a 2 stage heating system, set to Y to enable.
x
2nd Stage Cool Enable:
Enable second stage cooling
outputs.
If a single stage cooling system, leave this set to N.
If a two stage cooling system, set to Y to enable.
Thermostat Setup: Configure for HVAC
System
The thermostat must be set up for the correct HVAC system
type and configuration for proper operation.
Preset HVAC System settings
The thermostat is preset for the following typical HVAC
system configuration:
x
HVAC system type: Standard gas/electric
x
HVAC fan type: Gas heat
x
HVAC heating stages: one
x
HVAC cooling stages: one
If the thermostat is installed on this type HVAC system,
the System setup does not need to be changed.
Installation is complete.
For thermostats installed on a Heat Pump HVAC system or
any HVAC configuration other than the preset settings, the
System settings need to be changed in the SYSTEM setup
menu to match the HVAC system.
Changing the HVAC System Setup
To change the thermostats HVAC system settings, first
select the Menu Screen and then select the
SYSTEM
menu.
Follow instructions below to access the
SYSTEM
menu.
Note:
To conserve battery life, the thermostat backlight turns off
after a short time of no activity. The first press of any button
will turn on the backlight but will not initiate any action other
than turning on the backlight. Press the button again to
initiate the action desired. If the backlight is already on,
button presses work with the first press.
Go to Menu Screen
From the Thermostat Main Screen, press and hold the FAN
button
until the Menu screen is displayed.
Figure 8:
Main Screen
Menu Options
When the thermostat Menu Screen is displayed, use the Up
or Down
arrow buttons to scroll through the
following options:
x
SETUP
(user preference settings)
x
SYSTEM
(HVAC system setup)
x
ZWAVE
(install/uninstall from Z-Wave network)
x
HUMIDITY
x
INFO
(firmware versions and Z-Wave network
information)