Intergraph TDZ 2000 GT1, Справочное руководство системы

Страница: 52 / 108

40
‹
If you are installing a drive that connects to an adapter card, see the vendor’s
documentation for installing the adapter card and required cables. See the “Adding
Expansion Cards” section above for details.
‹
If you are installing a removable disk drive module, see the vendor’s documentation for
installing the module, removing terminators, and setting the SCSI ID.
NOTE Internal SCSI drives are not terminated. The internal SCSI cable provides termination. You
must disable termination on any drive that you install in the system.
Device Locations
You can add optional mass storage devices to the internal and external drive bays. The
following table provides the drive locations and related information. See the figure below.
Location Drive Peripheral Bay Max Bay Capacity SCSI ID
1 System disk drive Internal 3.5-inch x 1.0 or 1.6-inch 0
2 Optional disk drive Internal 3.5-inch x 1.0 or 1.6-inch 1
3 Optional disk drive Internal 3.5-inch x 1.0-inch 2
4 OptAdd-on device External 5.25-inch x 1.6-inch 3
5 Add-on device External 5.25-inch x 1.6-inch 4
6 Floppy drive External 3.55-inch x 1.0-inch —
7 CD-ROM External 5.25-inch x 1.6-inch —
NOTE You can install a total of three 3.5-inch x 1.0-inch drives or a total of two 3.5-inch x 1.6-inch
drives in the internal drive bay.
The following figure shows drive locations. Devices are installed in all locations for figure.
The CD-ROM, floppy drive, and system drive are standard. Other devices are available as
options.