15
4. Slide the new floppy drive into the chassis and align the mounting holes.
5. Install the two mounting screws.
6. Connect the data cable and the power cable.
CD-ROM Drive
To replace the CD-ROM drive:
1. Disconnect the power cable, data cable, and audio cable from the CD-ROM drive.
2. Remove the screws that secure the CD-ROM drive to the chassis. See the previous figure.
3. From inside the chassis, push the back of the CD-ROM until the bezel clears the chassis,
then slide the device out.
4. Remove the mounting guide from the right side of the CD-ROM. See the following
figure.
Mounting guide
5. Note the jumper settings on the rear of the CD-ROM.
6. Set the SCSI ID jumper on the new drive to the same address as the old drive.
7. Install the mounting guide on the right side of the new CD-ROM.
8. Slide the new CD-ROM drive into the chassis and align the mounting holes.
9. Install the screws that secure the CD-ROM to the chassis.
10. Connect the audio cable, data cable, and power cable.
